TR-One V3 Side Plate Upgrade Installation Guide
By Racing Simulators - World's Best Sim Rigs | Published: 2026-10-17
Category: How-to Guides
Learn how to upgrade your TR-One V1 or V2 wheel mount with the TR-One V3 side plate set for improved rigidity and compatibility.
Quick Answer
Upgrading your TR-One V1 or V2 wheel mount with the TR-One V3 side plate set replaces the original side plates with a patent-pending design that adds compatibility with the TR-One V3 2-Way Wheel Base Kit. The swap takes about 20 minutes and requires only basic tools.
What You Need Before Starting
The TR-One V3 side plate set includes four pieces designed to replace the side plates on your existing TR-One V1 or V2 wheel mount. You will need a 4 mm hex key (Allen wrench) and a clean, stable work surface. No drilling or cutting is required, but you should have the wheel base removed from the mount beforehand.
Understanding the Upgrade Benefits
The V3 side plates use a new geometry that reduces flex under heavy force feedback loads, especially noticeable with high-torque direct drive wheel bases. The upgrade also opens the door to the TR-One V3 2-Way Wheel Base Kit, which allows you to quickly switch between wheel bases or adjust the angle without tools.
Installation Steps
- Remove the Wheel Base: Detach your wheel base from the mount and set it aside. If your mount is on a rig, you can leave the mount attached to the profile. Common mistake: trying to swap plates with the wheel base still mounted can cause misalignment or damage to the base.
- Remove the Old Side Plates: Using a 4 mm hex key, remove the bolts securing the original side plates to the mount uprights. Keep the bolts and washers organized. Checkpoint: verify that the uprights are clean and free of debris before installing the new plates.
- Install the V3 Side Plates: Position the new V3 side plates against the uprights. Each plate has a specific orientation—the cutouts for the wheel base kit should face outward. Tighten the bolts evenly to avoid twisting the plate. Common mistake: over-tightening can strip the threads in the aluminum profile. Use moderate torque.
- Reattach the Wheel Base: Mount your wheel base back onto the V3 side plates using the original hardware. Ensure the base sits flush and the bolts are snug. Checkpoint: test for any play by gently rocking the wheel base—if you feel movement, recheck the bolt tightness.
Product Facts
- TR-One V3 2-Way Upgrade Side Plate Set (4 Pieces) — For TR-One V1 & V2 Wheel Mounts: TR ONE V3 2-Way Upgrade Side Plates — Upgrade your existing TR-One wheel mount to the latest generation with the Trak Racer TR ONE V3 2-Way Upgrade Side Plates. Designed to replace the original side plates found on TR-One V1 and TR-One V2 wheel mounting systems, this patent-pending upgrade enables compatibility with the advanced TR ONE V3 2-Way Wheel Base Kit. This upgrade directly addresses flex in earlier TR-One versions and adds future-proofing for the V3 wheel base kit, making it a practical choice if you plan to upgrade your wheel base later.
