Wireless Charging on Your Sim Rig: Mounting and Setup

By Racing Simulators - World's Best Sim Rigs | Published: 2026-11-03

Category: Guías prácticas

Keep your phone charged and within reach during long stints. Here is how to mount and set up a wireless charging station on your aluminium extrusion cockpit.

Quick answer

Mount the charging station on a horizontal or slightly angled extrusion profile within arm's reach, route the USB cable along the frame, and confirm your phone sits flat on the pad before tightening everything down.

Why placement matters more than the charger itself

A wireless charger only works reliably when the phone's charging coil lines up with the pad. On a sim rig, vibration and quick reach-ins can shift the phone, so the mount needs to hold it flat and secure. Avoid mounting on vertical uprights where gravity pulls the phone away from the pad, and keep the pad away from direct heat sources like power supplies or brake resistors.

Check your rig's extrusion before you buy

Most aluminium extrusion cockpits use standard T-slot profiles, but slot width and hardware vary between models. The Universal Wireless Charging Station with Mount is listed for aluminium extrusion cockpits including the TR8 PRO, TRX, TRF and similar rigs, but the product page does not specify which slot sizes or bracket hardware are included. Measure your profile slot and confirm the mount's compatibility before ordering, or plan to source T-nuts and bolts separately.

Mounting and setup steps

Pick the mounting location: Choose a horizontal or gently angled extrusion profile within easy reach of your seating position, such as a side shelf tube or the front accessory rail. Keep it clear of wheel rotation and pedal travel. Sit in your rig and reach for the spot before committing; if you have to lean far forward, choose another profile.
Test-fit the bracket and hardware: Slide the mount onto the profile and check that the bracket sits flush. If the supplied hardware does not match your slot width, source the correct T-nuts and bolts rather than forcing a loose fit. A bracket that rocks or slides by hand will move more once the rig is running.
Route the charging cable: Run the USB cable along the extrusion, using clips or zip ties to keep it away from moving parts and heat sources. Leave a small service loop at the charger end so the connector is not under tension. Check cable clearance through the full range of motion of your wheel and pedals.
Set the phone and confirm charging: Place your phone flat on the pad with the charging coil centered, then check that the charging indicator stays on. If charging cuts in and out, adjust the phone position or remove a thick case. Test with the phone in the case you actually use during sessions.
Tighten and vibration-check: Tighten all fasteners firmly, then run a short session or simulate vibration by tapping the frame. Re-check that the phone stays put and the charger does not rotate or slide. Re-tighten after the first few hours of use, as vibration can loosen new hardware.

Product facts

Universal Wireless Charging Station with Mount for Aluminum Extrusion Cockpits, TR8 PRO, TRX, TRF and More: Combines a compact simulator shelf with an integrated wireless charging pad, designed for racing and flight simulator cockpits. You get a dedicated spot for your phone without adding a separate shelf or cradle to the rig.
Universal Wireless Charging Station with Mount for Aluminum Extrusion Cockpits, TR8 PRO, TRX, TRF and More