Voltar ao blog
Guias Práticos 2026-11-20 Racing Simulators - World's Best Sim Rigs 1 visualizações

Universal Seat Slider Kit: Installation and Fit Guide

Universal Seat Slider Kit: Installation and Fit Guide

Learn how to install and fit the Universal Adjustable Dual-Lock Seat Slider Kit with 110mm adjustment. Compatible with most sim racing rigs and seats.

What This Seat Slider Kit Does

The Universal Adjustable Dual-Lock Seat Slider Kit gives you 110 mm of forward and 110 mm of backward travel, allowing you to fine-tune your seating position for comfort and control. Made from cold-rolled steel with a 2-year warranty, it's designed to handle intense racing sessions. This guide covers what the kit includes, which rigs and seats it fits, and how to approach installation based on the manufacturer's supplied information.

Kit Specifications at a Glance

Compatibility Notes Before You Start

The slider is designed as a universal component, but the supplied information notes that different widths of seats or rigs may require the adjustor bar to be bent outwards. This is a normal fitment step, not a defect. If your rig isn't listed, Trak Racer recommends contacting them to confirm compatibility before ordering.

The slider works with most Trak Racer seats and other seats that use standard mounting patterns. Seat brackets, seat belt harnesses, and seats themselves are sold separately.

Installation Steps Based on Supplied Information

The following steps are derived from the product's specifications and included components. Always refer to the manufacturer's full instructions if available.

  1. 1. Prepare the slider and seat: Remove the seat from your rig if it's already installed. Place the slider on a clean work surface. The kit includes one premium seat slider set with handle.
  2. 2. Attach the slider to the seat: Align the slider's mounting holes with the seat's mounting points. Use appropriate bolts (not included) to secure the slider to the seat. Tighten to the manufacturer's recommended torque if known.
  3. 3. Attach the slider to the rig: Position the seat and slider assembly on your rig's seat mounting brackets. Align the slider's lower mounting holes with the rig's bracket holes. Secure with bolts and washers (not included).
  4. 4. Adjust the slider bar if needed: If the adjustor bar contacts the seat or rig frame, gently bend it outward to clear the obstruction. This is a normal fitment step mentioned in the product documentation.
  5. 5. Test the sliding mechanism: Operate the ergonomic handle to slide the seat forward and backward through its full 110 mm range. Ensure smooth movement and that the dual-lock mechanism engages securely.

What the Supplied Information Leaves Open

The product listing does not specify exact bolt size or thread pitch required for mounting. You may need to check your seat and rig documentation for the correct hardware. Torque values are also not provided—tighten bolts firmly but avoid over-tightening. If you encounter fitment issues with non-Trak Racer rigs, measure your mounting hole spacing against the slider's 340 mm total length before proceeding.

Artigos relacionados

Customer Service
Início
Produtos
Carrinho
Perfil